Genie 1022 Manual De Instrucciones página 13

MOUNTING THE OPENER:
1. Getting started.
• Position assembled rail on wall next to header
bracket (Fig. 2-4).
– Place material on floor under power head to
protect from scratching. (A box, stool, or
similar device may be needed to clear a
torsion spring.)
NOTE: For header bracket pins locate Bag 2 from
Box 1.
2. Mounting the assembly.
• Attach rail to header bracket using clevis pin
and cotter pin (Fig. 2-5).
• Support power head on step-ladder to prevent
interference with header mounted (torsion)
spring.
NOTE: Before final attachment to ceiling, insure
that assembly is in proper alignment (Fig. 2-4).
NOTE: For nuts, bolts, and lag screws locate Bag
3 from Box 1.
• On finished ceilings, locate ceiling joists or
trusses using a stud finder or similar device.
Attach angle iron (not provided) to joists or
trusses through finish material using (provided)
lag screws (Fig. 2-6).
• On unfinished ceilings or open ceilings, straps
may attach directly to joists or trusses.
Depending on the garage construction, extra
framing material (not provided) which may be
required should be installed using appropriate
construction techniques (Fig. 2-6).
NOTE: Refer to your local building codes for
appropriate framing materials and construction
techniques.
• Attach mounting straps (not provided) to ceiling
using lag bolts (Fig. 2-6).
• Set height of power head to following (Fig. 2-6).
a) Rail must clear door at door's highest point
of travel.
b) Be level or power head slightly below level.
• Securely tighten power head mounting bolts
and nuts.
• Carefully raise and lower door manually. Ensure
door does not contact any section of power head
or rail.
• Check that rail clamp bolts and nuts are tight.
• DO NOT PLUG OPENER IN YET!
HEADER BRACKET
FIG. 2-4
FIG. 2-5 Rail mounting to header bracket
ANGLE IRON ON FINISHED CEILING
bolts & nuts
FIG. 2-6
PN# 3642036534, 02/26/2010 REV. 1
VIEW
FROM ABOVE
(not to scale)
YES / SÍ / OUI
Position assembly and align.
COTTER PIN
CLEVIS PIN
Attach angle iron to beams
UNFINISHED OR OPEN BEAM
Extra framing
not needed
Mounting Straps
(not provided)
Extra framing
NEEDED
Mounting the power head.
(Chain drive
shown)
.
DRYWALL
bolts & nuts
13