Battery/Visor Clip Installation; Light Bulb And Lens Installation - Genie 1022 Manual De Instrucciones

8
REMOTE CONTROL
1. Battery replacement.
• To open gently push straight out on battery
cover lock tab as shown (Fig. 8-1).
• Flip open battery cover.
– Remove old battery.
• Make sure new battery is facing proper direction
(Match battery polarity with symbols inside
battery cover) (Fig. 8-2).
– Recommended replacement battery type:
Alkaline A23, 12 volt.
NOTE: Batteries differ in care and maintenance.
Follow the manufacturer's directions for battery
maintenance, replacement, and use.
• Slip new battery into place.
– Slide battery cover until it clicks shut.
• Operate remote to make sure it is working
properly. (No re-programming is needed.)
2. Visor clip.
(The visor clip may come already installed.)You
will have to install the visor clip if you choose to
attach your remote to the car visor.
• Slide visor clip into back of remote control.
– It will snap into place (Fig. 8-3).
9
LIGHT BULB / LENS INSTALLATION
For added safety and protection please unplug
opener before installing light bulb.
NOTE: For lens cover locate Box 4.
1. Light bulb.
• Recommendations.
– Do NOT use a short neck bulb.
– Light bulb should be no more than 75 Watts.
– Use a heavy duty service bulb for longer life.
• Screw bulb into socket.
2. Lens.
• Select the white (lamp) cover. Do NOT use the
colored cover in this location.
• Line up lamp lens tabs on power head with
corresponding slots in lens (Fig. 9-1).
• Slide lens onto power head. Make sure the tabs
are fully engaged into lens slots (Fig. 9-2).
• Plug power cord back into electrical outlet.
24
BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION
WARNING
PN# 3642036534, 02/26/2010 REV. 1
Slide out
FIG. 8-1 Open battery cover.
FIG. 8-2 Match battery polarity.
FIG. 8-3 Attach visor clip.
Lens tabs
FIG. 9-1 Slide lens onto motor cover.
FIG. 9-2 Fasten lens.
– and + polarity marks
Light bulb