Safe-T-Beam System Installation - Genie 1022 Manual De Instrucciones

4
®
SAFE-T-BEAM
WARNING
There should be no electrical power to the opener
while installing Safe-T-Beam
plugged in the power cord—UNPLUG IT NOW!
NOTE: The opener will not close the door
automatically unless the Safe-T-Beam
installed.
NOTE: For Sensors, screws, wire, and insulated
staples locate items and Bag 8 from Box 3.
1. Mounting brackets.
• Mark both sides of garage door frame or wall no
higher than 6" and no lower than 5" above floor
(Fig. 4-1).
• Hold bracket against door frame or wall.
– Check if brackets extend out from wall far
enough, so tongue of bracket is beyond door,
tracks or any door hardware.
– If not:
a) Mounting bracket extensions are available
through an authorized Genie
b) Blocks of wood, etc. may be substituted for
extensions.
• Center bracket on your mark (Fig. 4-2).
• Fasten each with 2 screws (Fig. 4-2).
NOTE: Mounting brackets can be attached to the
floor or concrete rim using concrete anchors
(not provided).
2. Mounting Safe-T-Beam
Sensor (Green LED).
• If garage has only one garage door.
– Determine which side of garage receives most
direct sunlight (Fig. 4-4).
– Red LED should always be on sunny side
whenever possible (Fig. 4-4).
• For multiple doors.
– Preventing crossed signals is critical.
– Place source and sensor modules on adjacent
doors facing in opposite directions (Fig. 4-4).
NOTE: To help prevent interference from sun,
Safe-T-Beam ® sensor with Green LED may be
placed further away from the door opening,
though extended no further out from the wall,
where it will spend more time in shadow.
• Slide source/sensor onto tongue of bracket until
it clicks into place (Fig. 4-3).
3a. Wiring (If NOT pre-wired).
• Route wire from Safe-T-Beam
head using method shown in (Fig. 4-5a).
• Securely fasten wires to wall and ceiling
as you go (Fig. 4-6 on next page).
– Use insulated staples.
– Staples should be snug only.
SYSTEM INSTALLATION
® wires. If you have
® System is
® Dealer.
® Source (Red LED) and
® sensors to power
Insulated
Staple
PN# 3642036534, 02/26/2010 REV. 1
FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
FIG. 4-1 Mark door frame
center of
bracket
FIG. 4-2
.
Mounting brackets
SUN
RED GREEN GREEN
LED LED
LED
TWO DOOR
ONE DOOR
GARAGE
GARAGE
GREEN RED RED
LED LED LED
THREE DOOR
GARAGE
FIG. 4-4 Safe-T-Beam ®
.
locations
Red Green
Source Sensor
Power
Head
FIG. 4-5a Source and sensor wiring methods
mark
.
bracket
tongue
FIG. 4-3 Attach
.
sensors to brackets
RED RED GREEN
LED LED LED
GREEN GREEN RED
LED LED LED
source and sensor
or
6 5 4 3 2 1
6 5 4 3 2 1
Dashed Line = striped wire
Solid Line = white wire
.
17