Preparing The Icemaker For Long Storage - Hoshizaki FM-1000AKE Manual De Instrucciones

hands.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
* Young children should be supervised
to ensure that they do not play with the
appliance.
* Do not attempt to modify the icemaker.
O n l y q u a l i f i e d p e r s o n n e l m a y
disassemble or repair the appliance.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the icemaker to
prevent damage to the compressor.
1. START UP
The installer will normally commission the icemaker
to start the automatic icemaking process. To
ensure continuous operation, make sure that:
* The water supply tap is on, and
* The icemaker is connected to the power supply.
To start the icemaking process, check the position
of the operation switch on the operation panel:
"OFF" position - Move it to the "ON" position.
"ON" position - Press the ice button.
Operation Panel
Ice Button Display Stop Button
Maintenance Button
(service use only)
Fig. 1
2. SHUT DOWN
Push the stop button on the operation panel.
The display will blink in the "STOP" mode for 15
minutes during the drain control operation and will
start to illumintate constantly at the end of drain
control.
3. PREPARING THE ICEMAKER FOR LONG
1) Follow the instructions in "2. SHUT DOWN".
2) Close the water supply line shut-off valve.
3) Open the drain valve.
4) Press the ice button on the operation panel to
5) When no more water comes out of the drain
6) Move the operation switch to the "OFF" position,
7) Close the drain valve.
8) Remove all ice from the storage bin, and clean
III. MAINTENANCE
1. CLEANING
Operation Switch
3
STORAGE
drain the water circuit.
valve, press the stop button.
and disconnect the power supply.
the bin.
WARNING
1. B e f o r e c a r r y i n g o u t a n y c l e a n i n g o r
maintenance operations, disconnect
the icemaker from the electrical supply
network.
2. Ask a trained service person to check and
clean the condenser at least once a year.
3. This appliance must not be cleaned by use
of a water jet.
4. To prevent possible damage, do not clean
the plastic parts with water above 40°C or
in a dishwasher.
ENGLISH