Manusa Visio Manual De Instrucciones página 16

DUSI01EN - v5
1.3– COMPATIBILITY
All doors equipped with a VISIO operator are compatible with practically the entire range of
ACTIVATION
- Smart Selector.
- Optima selector:
· remote control (optional)
- Outside key switch:
· flushed mounted
· surface mounted
- Opening push button.
- Elbow switch.
- Emergency stop.
2– USE: USES INCLUDED AND USES THAT SHOULD BE AVOIDED
manusa automatic doors are designed to allow passage of pedestrians without the need for pedestrians to activate any
controls or components.
Prohibited uses that should be avoided are listed below:
- Do not modify the door or any of its components.
- Do not allow children to play with the door.
- Do not disconnect, manipulate or decommission any of the door's safety components.
- Do not allow technicians not authorised by manusa to perform work on the door.
- Do not use spare parts that are not original and supplied by manusa.
- Do not use any part of the door as a support for objects or persons.
This list includes inappropriate uses of the door that are reasonably foreseeable. Despite this, manusa shall not be held
responsible for possible accidents or damage caused by inappropriate uses that are not included in the list above.
3– OPERATION AND USE
3.1– LOCATION. PHYSICAL AND ENVIRONMENTAL REQUIREMENTS
manusa automatic doors must be installed in locations that meet the following conditions:
- Smooth, even and levelled floors.
- Stable walls with sufficient load capacity.
- Levelled partitioning.
- Absence of vibrations and impacts on the door area.
- Service temperature: from -15ºC to +50ºC.
- Relative air humidity: The electric and electronic components of operators manufactured to operate in tropical climates
receive a surface treatment that protects them from environmental humidity.
3.2– OPERATING PRINCIPLES
manusa automatic doors operate only in automatic mode. Manual operation is only available in the event of an emergency
and to perform cleaning, maintenance and adjustment tasks.
3.2.1.– Commissioning
Checks and adjustments prior to the commissioning of manusa automatic doors can only be performed by authorised
technical personnel.
3.2.2.– Normal stop and emergency stop
Commissioning and normal stop of manusa automatic doors is performed automatically. Emergency situations are managed
automatically by the equipment itself. However, an optional emergency stop can be installed (see Section 3.7).
DETECTION
- Planar radar (microwave)
- IR sensor
- Flushed IR sensor
- IR touch-less switch .
- Safety photocell.
16
AUTOMATIC DOOR WITH VISIO OPERATOR - USER MANUAL
manusa
CONTROL / OTHER
- Ethernet Adapter (Gateway)
- Numeric key-pad
- Interface:
· Basic.
· Airlock
· Special, programmed to client specifications.
- Proximity badge reader.
- Remote control with rolling code
- Mechanical fail-safe (CO-48)
- Electromechanical lock with manual release.
- Cover lock
accessories.