Spare Parts - Manusa Visio Manual De Instrucciones

DUSI01EN - v5
5– MAINTENANCE
Maintenance of the manusa door can only be carried out by authorised technical personnel.
The maintenance tasks reserved for users are exclusively restricted to keeping the door area tidy, clear and clean.
5.1– SPARE PARTS
All spare parts must be manusa original parts and must be installed by an authorised technician.
manusa is not responsible under any circumstances for damage that may be caused by non-compliance with these guide-
lines.
5.2– MANUAL OPERATION - DOOR CLEANING
Regular maintenance and proper cleaning of the vairous elements of your automatic manusa door will allow you to enjoy your product in
top condition and with an extended service life.
· To begin cleaning the door, select the door OPEN operating mode on the selector. This allows you to move the door leaves freely for
simpler and more convenient cleaning.
· To restore normal door operation, select the AUTOMATIC door operating mode.
Below we include detailed instructions for cleaning the various product components.
Stainless steel
5.3– DOOR DECOMMISSIONING AND DISMANTLING
The operator can be easily removed, while decommissioning does not have special complications. Proceed to dismantle the operator in
different elements and proceed to discard and recycle all elements after use.
The drive unit must be disconnected from the power supply before removing the batteries.
The batteries must be destroyed safely.
Clean with a soapy hot water or rub with a glass cleaning product and a soft cloth.
Glass
If the glass is very dirty, add drops of vinegar or ammonium.
Be careful not to apply any chemical products to the rubber sealing in the glass door
frames.
There ara plenty of suitable products on the market that are specific for restoring aluminium,
Aluminium
whether anodised or lacquered, and giving it back its lustre without damaging the glass or
sealing.
The use of acid, base, abrasive or hot products should be completely avoided.
For indoor installations, simply keep the surface clean with a clean cloth or soapy cold wáter
and rinse and dry afterwards with a cloth. For outdoor installations, use neutral synthetic
products applied with a soft cloth and rinse with cold water.
If any of the door components (door leaves and operator) is lined in stainless steel,
take into account the following cleaning requirements.
Stainless steel requires minimum maintenance. Clean with:
- A soft cloth and a sponge dipped in soapy water.
- A slightly wet micro-fibre dishcloth.
- For more difficult stains, use a normal cream cleaner.
- Dry the wet surface to prevent water and limescale marks.
- Do not use:
- Abrasive and solvent products.
- Steel Wood pads.
- Bleaches and cleaning products containing chloride.
If you use an acid product or solvent, rinse thoroughly with neutral water.
There are polishing creams that leave a microscopic wax film that is very resistant,
lasts several months and greatly facilities cleaning.
Always clean the command and detection devices in the door with a slightly damp
Accessories
cloth.
Never pour fluid of any kind on these accesories.
AUTOMATIC DOOR WITH VISIO OPERATOR - USER MANUAL
23