Eizo FlexScan HD2442W Manual Del Usuario página 17

Prior to use
No-Picture Problem
If no picture is displayed on the monitor even after the following remedial action is taken, contact your local dealer.
1. Check the Power indicator.
Symptom
No picture
* For details of the gain adjustment and field rate setting, please refer to the User's Manual on the CD-ROM.
2. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom
Installation Setting/Adjustment
Status
Power indicator does not light
up.
Power indicator lights orange.
Power indicator lights blue.
Status
The frequency of the signal
sent from the PC is outside the
specification.
(Such signal frequency is
displayed in red.)
The frequency of the signal
sent from the AV equipment is
outside the specification.
Troubleshooting
Possible cause and remedy
Check whether the power cord is correctly
connected.
Press on the remote control (or touch of
the operation switch).
Switch the input signal with [INPUT SELECT]
( / ) on the remote control (or with
of the operation switch).
(When PC signal is input,)
Press a key on the keyboard or click the mouse.
Turn on the PC.
(When HDMI signal is input,)
Turn on the AV equipment.
Check whether the external equipment is
properly connected to the monitor.
(When PC signal is input,)
Check the gain * setting.
(When HDMI signal is input,)
Check the field rate * setting.
Possible cause and remedy
Change the mode appropriately using the
graphics board's utility software. Refer to the
manual of the graphics board for details.
(When HDMI signal is input,)
Confirm the digital signal format by referring to
the manual of the equipment connected.
15