Axxess MITO-02 Instrucciones De Instalación página 3

Initializing and adjusting
the MITO-02
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, and on again.
• If the speakers are too loud, or not loud enough, you can adjust the output by
following the steps below:
1) Locate the end of the MITO-02 with the 14-pin harness with stripped leads
and RCA jacks.
2) Using a small flat-blade screwdriver, turn the gain knob clockwise to make it
louder, or counterclockwise to make it lower.
(Figure A)
MITO-02
Mid/High
speaker control
Subwoofer control
3
Notes