Connections To Be Made - Axxess MITO-02 Instrucciones De Instalación

From the 14-pin harness to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire (this wire must be
connected to hear sound from the factory amplifier).
• Tape off and disregard the Brown wire, it will not be used in this application.
• Connect the White RCA to the left front output.
• Connect the Gray RCA to the right front output.
• Connect the Green RCA to the left rear output.
• Connect the Purple RCA to the right rear output.
Note: If the radio does not have RCA outputs, or only one pair, use the Axxess
ALOC648 (4 Ch.) or ALOC608 (2 Ch.) line level convertors (sold separately).
The following wires are for aftermarket multimedia/navigation radios that provide
these wires (if not required, tape them off and disregard them):
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the speed sense/ V.S.S. wire.
• Connect the Green/Purple wire to the reverse wire.
MITO-02

Connections to be made

• Plug the 14-pin harness into the MITO-02
From the MITO-02 harness:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna turn-on wire.
• Connect the Orange wire to the Illumination wire. (If the aftermarket radio has
• Connect the 16-pin harness into the MITO-02.
• Connect the 18-pin and 20-pin harness into the vehicle.
2
Note: Reverse wire is not available on manual transmission vehicles.
no Illumination wire, tape off the Orange wire.)