Technical Specifications - Slendertone Abs 7 Instrucciones De Uso

TECHNICAL SPECIFICATIONS

Caring for your controller
Your controller should not be allowed to get wet or be left in excessive sunlight. Itv may be cleaned regularly
using a soft cloth, lightly dampened in soapy water. Do not allow the interior of your controller to become wet.
Do not use detergents, alcohol, spray aerosols or strong solvents on your controller.
Access to the interior of the controller is not required for maintenance purposes.
If your controller is damaged, you should not use it but should return it to
replacement or repair. Repairs, service and modifications may not be carried out by anyone other than qualified
service personnel authorised by
: Under no circumstance should anything other than the correct type of batteries - (rechargeable
IMPORTANT
batteries 3.6V NiMH) be used with your controller. These can be purchased from the
Disposing of the gel pads and batteries
Used gel pads and batteries must never be disposed of in a fire but in accordance with your country's national
laws governing the disposal of such items.
Accessories:
Under no circumstances should anything other than
charger or
SLENDERTONE
degrade the minimum safety levels. You can purchase all accessories at www.slendertone.com.
7 Gel Pads: • 1 large adhesive gel pad (Type 732)
SLENDERTONE ABS
Battery Pack: (3.6V, NiMH)
Battery Charger:
EU: 2504-0303 / (2504-0311 + 2504-0316 + 2504-0317)
US/Japan: 2504-0302 / 2504-0312
Australia: (2504-0311 + 2504-0319)
Charger complies to EN 60950, Input: nominal voltage 100-240V, frequency 50-60Hz, current 125mA. Do not
use any other chargers or any other power supplies.
Classification: Internally powered equipment, Class II charger, Type BF applied parts.
Product Type: 390
Intended use: Muscle stimulator 390
Waveform: Symmetrical bi-phasic square waveform when measured into a resistive load.
Attention:
This product can deliver currents in excess of 2mA/cm² if used with incorrect electrodes.
:
NOTE
The signal gradually increases to a peak intensity level at the start of the contraction phase (i.e. ramp up) and
gradually decreases to nothing at the start of the relaxation phase (i.e. ramp down). When the
flashing, the stimulus is significantly reduced.
Environmental Specifications:
Operating:
Transport & Storage: Temperature Range: 0 - 55°C (32 - 131°F)
18
.
SLENDERTONE
controller (Type 390). Any others may not be compatible with your controller and could
• 2 small adhesive gel pads (Type 733)
Temperature Range: 0 - 35°C (32 - 95°F)
Humidity: 20 - 65 % RH
Humidity: 10 - 90 % RH
SLENDERTONE
accessories be used with your
SLENDERTONE
or your local distributor for
careline.
SLENDERTONE
SLENDERTONE
symbol is