Technical Specifications; Product Warranty - Slendertone Ab S6 Manual De Instrucciones

technical specifications

Caring for your controller
Your controller should not be allowed to get wet or be left in
excessive sunlight. It may be cleaned regularly using a soft cloth,
lightly dampened in soapy water. Do not allow the interior of
your controller to become wet. Do not use detergents, alcohol,
spray aerosols or strong solvents on your controller.
Access to the interior of the controller is not required for
maintenance purposes.
If your controller is damaged, you should not use it but should
return it to or your local distributor for replacement
SLENDERTONE
or repair. Repairs, service and modifications may not be carried
out by anyone other than qualified service personnel authorised
by .
SLENDERTONE
: Under no circumstance should anything other than the
IMPORTANT
correct type of batteries – (rechargeable batteries 3.6V NiMH)
be used with your controller. These can be purchased from the
Careline.
SLENDERTONE
Disposing of the GelPads and batteries
Used GelPads and batteries must never be disposed of in a fire
but in accordance with your country's national laws governing
the disposal of such items.
: The signal gradually increases to a peak intensity level at
NOTES
the start of the contraction phase (i.e. ramp up) and gradually
decreases to nothing at the start of the relaxation phase (i.e.
ramp down). When the ramp down). When the symbol is flashing, the stimulus is symbol is flashing, the stimulus is
significantly reduced.
Accessories:
You can purchase all accessories at www.slendertone.com.
Under no circumstances should anything other than
accessories be used with your charger or
SLENDERTONE
controller (Type 390). Any others may not be compatible with
your controller and could degrade the minimum safety levels.
7 GelPads: • 1 large GelPad (Type 732)
SLENDERTONE ABS
• 2 small GelPads (Type 733)
Battery pack (3.6V, NiMH)
Battery Chargers:
EU 2504-0303 / (2504-0311 + 2504-0316 + 2504-0317)
US/Japan: 2504-0302 / 2504-0312
Australia: (2504-0311 + 2504-0319)
Charger complies to IEC 60950 and UL 1950, Input: nominal voltage
100-240V, frequency 50-60Hz, current 90mA. Output: 6V / 550mA.
Do not use any other chargers or any other power supplies.
Product Type: 390
Intended use: Muscle stimulator
Classification: Internally powered equipment, Class II charger,
Type BF applied parts.
Waveform: Symmetrical bi-phasic square waveform when
measured into a resistive load.
Environmental Specifications:
Operating: Temperature Range: 0 - 35°C (32 - 95°F)
Humidity: 20 - 65 % RH
Transport & Temperature Range: 0 - 55°C (32 - 131°F)
Storage: Humidity: 20 - 85 % RH
16
Attention:
This product can deliver currents in excess of 2mA/cm
with incorrect electrodes.
Description of your controller's symbols:
There are a number of technical markings on your controller.
These can be explained as follows:
The product is manufactured for Bio-Medical Research
Ltd, Parkmore Business Park West, Galway, Ireland.
The controller requires 1 x 3.6 volt (NiMH) DC battery pack DC is
indicated by the symbol:
The Output Frequency indicates the number of pulses per second
transmitted by the product. This is measured in hertz, which is
indicated by "Hz".
Output (RMSA) means the maximum output root mean square
current for each channel.
Output (RMSV) means the maximum output root mean square
voltage for each channel.
This symbol means "Attention, consult the accompanying
!
documents".
This symbol means type BF applied parts.
SN stands for 'serial number'. Inside the box, on the back of the
controller is the serial number specific to this product. The letter
preceding the number indicates the year of manufacture, where
"T" denotes 2014, "U" denotes 2015 etc.
The belt's batch number is represented on the belt packaging, by
SLENDERTONE
the number corresponding with the LOT symbol.
SLENDERTONE
Rated Outputs – Voltage/Currents: E :10 and X :10
Parameter 500"
Output RMSV 6.4V
Output RMSA 12.7mA
Output Frequency 50-70Hz
DC Component: Approx. 0 C
Positive Pulse Width: 200-300µs
Negative Pulse Width: 200-300µs
Interphase Interval: 100 µs
At the end of the product lifecycle, do not throw this
product into the normal household garbage, but bring
it to a collection point for the recycling of electronic
equipment.
Some product materials can be re-used if you bring them
to a recycling point. By re-using some parts or raw materials
from used products you make an important contribution to
the protection of the environment. Please contact your local
authorities if you need more information about collection
points in your area.
Waste Electrical and Electronic Equipment can have
potentially harmful effects on the environment. Incorrect
disposal can cause harmful toxins to build up in the air,
water and soil and can be harmful to human health.

product warranty

Dear Customer,
2 if used
Thank you for purchasing your
must have been purchased directly from Slendertone Distribution, Inc. ("SDI"), or its authorized retailer in the
United States. This Limited Warranty extends only to the original purchaser and cannot be transferred to anyone.
Please read this carefully before using the Product.
Our Limited Warranty to you
SDI
WARRANTS TO YOU
NORMAL USE AND SERVICE
IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF TWO
FROM THE DATE OF PURCHASE
A DEFECT COVERED BY THIS
W P
ARRANTY ERIOD
REPAIR OR REPLACE THE
REMANUFACTURED COMPONENTS
OF ANY KIND AS TO ANY DEFECTS DISCOVERED AFTER THE
P .
ERIOD EXPIRES
Certain Product failures not covered
This Limited Warranty covers defects in manufacture that
arise from correct use of the Product per the product
manual and instructions. It does not cover damage
caused by abuse, misuse, accidents, modification or
repair by any person other than SDI, moisture, extreme
heat or cold, corrosive environments, high voltage surges
from external sources or an unsuitable power supply.
This Limited Warranty does not cover normal wear and
tear on consumable items (e.g. GelPads, garments, etc.).
This Limited Warranty does not apply to any battery pro-
vided with the Product, or if the Product has an altered or
defaced serial number.
How to obtain service under this Limited Warranty
To obtain service under this Limited Warranty, please
1K" 1K5"
contact SDI's Customer CareLine at 1-800-551-2443
12.7V 12.7V
to obtain return instructions. You must submit proof of
12.7mA 8.5mA
purchase in the form of a bona fide, dated bill of sale,
50-70Hz 50-70Hz
receipt, or invoice (or copy thereof ) evidencing that your
0 C 0 C
200-300µs 200-300µs request for service is made within the Warranty Period.
200-300µs 200-300µs
100 µs 100 µs
Except as may otherwise be required by legislation in
your State, SDI will not be responsible for the cost of
returning the Product or for any damage to or loss of the
Product while it is in transit to us. We recommend that
you use a carrier that will track your shipment and ensure
the Product's safe delivery. SDI cannot accept any returns
sent C.O.D.
THIS LIMITED WARRANTY IS THE ONLY WARRANTY FOR
THE PRODUCT, AND THERE ARE NO OTHER EXPRESS
WARRANTIES, ORAL OR WRITTEN, PROVIDED BY SDI.
ANY IMPLIED WARRANTIES APPLICABLE TO THE
PRODUCT, INCLUDING
MERCHANTABILITY OR FITNESS FOR A PARTICULAR
product ("Product"). To be covered by this Limited Warranty, the Product
SLENDERTONE
PURPOSE, ARE LIMITED TO THE DURATION OF THE
, , WARRANTY PERIOD SET FORTH ABOVE.
THE ORIGINAL PURCHASER THAT UNDER
, P
THE RODUCT WILL BE FREE FROM DEFECTS
(2) Limitation of Remedies
YEARS
("W P "). I YOUR
ARRANTY ERIOD F YOU DISCOVER
L W INDIRECT, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY,
IMITED ARRANTY DURING THE
, P , SPECIAL OR OTHER DAMAGES OF ANY KIND, INCLUDING
AND RETURN THE RODUCT TO US WE WILL
P , , FOR NEGLIGENCE, IS LIMITED TO THE REPAIR OR
RODUCT AT OUR OPTION USING NEW OR
. T REPLACEMENT OF THE PRODUCT, IF DEFECTIVE, UNDER
HERE IS NO WARRANTY OR CONDITION
W THE TERMS AND CONDITIONS OF THIS LIMITED
ARRANTY
WARRANTY.
SDI will bear no other expenses.
SDI reserves the right to refuse to repair or replace the
Product if it is returned in an unsanitary condition. SDI
reserves the right to substitute a product of equal or
better quality if an identical product is not available at
the time of replacement. This Limited Warranty is non-
transferable.
Applicability of state law
Some states do not allow limitations on the duration of
implied warranties, or the exclusion or limitation of
incidental or consequential damages, and so the related
limitations and exclusions stated above may not apply
to you.
Governing law
This Limited Warranty is valid in the United States only
and is not applicable in other countries. If you acquired
the Product in the United States, the laws of the State of
New York will apply to this Limited Warranty.
THIS LIMITED WARRANTY GIVES YOU SPECIFIC LEGAL
RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS,
WHICH VARY FROM STATE TO STATE.
ANY WARRANTIES OF
EXCLUSIVE REMEDY, IN LIEU OF ALL
17