Configuration And During The Reproduction; Use Of Ap602 And Bp012 Alone - CESVA FP122 Manual Del Usuario

AP602

4.3.2 Configuration and during the reproduction

See 4.2.2 and 4.2.3(4.1.3)
NOTE:

The stop and start, equalizing and volume controls of the noise
reproduction concerns to the signal amplification stage. In this way, the
signal from the external signal processing equipment can be controlled
from the AP602 (remote control or AP602 software).

4.4 Use of AP602 and BP012 alone

The standard configuration of the FP122 consist in reproducing with the BP012
loudspeaker the noise signal generated, equalized and amplified by the AP602.
The BP012 has an omnidirectional radiation diagram and can develop up to 123
dB PWL of acoustic power when fed with the AP602. The BP012 also can work
with other amplifiers. To set that configuration, just connect the loudspeaker
output of the amplifier to the Speakon connector [2] of the BP012. For technical
characteristics of this input see 7.2.
NOTE:

Always connect the equipment with the equipment turned off and consult
the chapter 8 about safety measures and advice.

Make sure the power amplifier characteristics are suitable to work with the
BP012.

is not responsible for damage caused to BP012 produced by
external equipment.
Chapter 4 Configuration and use of FP122
External processing equipment
CN012
BP012
TR012
55