CESVA FP122 Manual Del Usuario página 70


In case there is any kind of intervention and/or connection-disconnection of
the amplifier, it is most important to previously disconnect the mains power
supply.

The AP602 is protected with a transport case. Do not remove the AP602 from
this case. This operation only must be done by qualified and authorised
technician. Do not manipulate the output terminals to the loudspeaker when
the amplifier is switched on, there are voltages up to 400 Vpp. There is no
user or serviceable part inside the AP602.

The mains cable must not be near the cables carrying the audio signal, as this
could cause humming.

To protect the amplifier from eventual over charges of consumption, it has al
fuse. Should the fuse blow, it must be replaced immediately by
technical Service department.

indicator appears when an internal protection is active: Temperature
protection, overload protection, etc. It also can appear momentarily when
switching on the equipment.

indicator appears when the maximum current or voltage values at the
amplifier output are exceeded and the AP602 applies the clipping limitation. It
also can appear momentarily during stabilization of the equipment when
switching it on.

indicator could appear while AP602 is switched on and it will disappear in
a few seconds. If not, try switching off the equipment, wait a few minutes and
re-start the AP602. If the indication remains, contact your

When you start the AP602, the
while the equipment is stabilizing. During this time, the AP602 is not
operational. Once the AP602 is ready, the
using external equipment, always turn them on before turning on the amplifier
and turn them off when the amplifier is off.

indicator is also a signal clipping indicator. Ensure that this indicator does
not appear when working with high power levels. This could damage the
speaker connected to the AP602.

If the sound would stop playing, turn off the equipment, wait a few minutes
and then restart the AP602. If you still do not hear the reproduced noise,
contact your

The AP602 is designed to work horizontally. Any other working positions
should be avoided.

This equipment only can work with the accessories mentioned in the
accessories section. In case that using a different accessories and that this
causes a failure in the equipment,
failure. Then the equipment will lose its warranty.

Always place the AN001 antenna in the AP602 to be able to control it with the
MA001 remote control.

Remember to fold or to remove the antenna AN001 before closing the AP602.

Be especially careful with the folding the AN001 antenna orientation. Since
this has a single folding direction and if it is not respected then the AN001
antenna could be damaged.
68
indicator will appear for a few seconds
dealer.
Chapter 8
indicator will disappear. When
would not be responsible of this
Safety measures and advice
dealer.