Safety Measures And Advice On The Connecting Cables; General Safety Measures And Advices - CESVA FP122 Manual Del Usuario

8.3 Safety Measures and advice on the connecting cables


If you are using a loudspeaker cable different of the CN0012, check that the
pin-out is correct and that the cable width is 1.5 mm as a minimum.

When using line signal cables to connect the AP602 with external equipment
(audio processors, external noise generators, ...) check the impedance and
the input / output voltage levels data in the technical specifications and also
that the pin-out is correct.

8.4 General safety measures and advices


The reproduction of signals other than those generated by the AP602 or
modified by external equipment are the responsibility of the user. In these
cases

Before working with swept sine signals please contact to

When using the AP602 connected to the BP012, any equipment inserted
between the noise generator, of the AP602, and the equalizer, of the AP602,
must not introduce any gain or distortion. Because this can damage the
AP602 and/or BP012.

would not be responsible of any damage caused by connecting
equipment to other equipment.

Both the AP602 and the BP012 although they have been designed to be very
robust, they should be treated with care when moving or handling them. It is
specially recommended to always pick them up by their grips and transport
them inside the carrying cases specially designed for them. Especially the
BP012 due to its weight
Chapter 8 Safety measures and advice
would not be responsible of any damage caused.
.
69