Remote Control With A Pc; Control By Usb Cable; Control By Bluetooth Wireless Communication - CESVA FP122 Manual Del Usuario

5.2 Remote control with a PC

The AP602 has the software application SF600 (AP600 Remote Control) that
allows you to control it remotely. See the help file of the SF600 software.
There are two ways to do this control:

5.2.1 Control by USB cable

El AP602 can be connected to a PC by means of the CN2US cable through the
USB port [21].
When you make this connection for the first time, the installation of a certified
driver is required. You will find it in the
product page.
Follow the installation instructions and obtain the assigned COM port. You will
also find instructions on how changing the assigned port. This COM port is the
one you should entre at the SF600 software.
It is very important to remember which USB port of the PC was used in the
installation process and always use the same one; if not, new additional COM
ports are likely to be generated.
5.2.2 Control by Bluetooth
The AP602 has a properly configured internal Bluetooth
device.
To wireless control the AP602 with the SF600 software, take the following steps:

Connect the BT002 Bluetooth
you are connecting it for the first time, you should follow the installation
process indicated in the corresponding manual.

Switch on the AP602.

Run the SF600 (AP600 Remote Control) Software and select the assigned
COM port and make the connection.
From that moment you can comfortably control the AP602 from the PC.
NOTA:

®
Bluetooth wireless technology is used in measurements of sound
insulation between rooms because communication can be established
through walls.

do not guarantee the success of communication, and is not
responsible for any inconvenience that may arise working with a Bluetooth
wireless communication device different from BT002.
58
®
wireless communication
®
wireless communication device to the PC. If
web site, at the FP122
®
wireless communication
Chapter 5 Remote control
®