Product Description - Ottobock 60X1 Instrucciones De Uso

These instructions for use provide you with important information on the use, adaptation and
handling of the product.
Only put the product into use in accordance with the information contained in the accompanying
documents supplied.

2 Product description

2.1 Design
The USB fibre optics adapter is equipped with the following light-emitting diodes (LEDs) and
connections:
2.2 Function
The 60X1 USB fibre optics adapter enables communication between Ottobock products with a
fibre optics connection and the USB port of a PC.
2.3 Combination possibilities
This product can be combined with the following Ottobock components:
• 757T8 Tricorder
• 757T11 MyoCom
• 757T15 Testtronic
• C-Leg knee joints: 3C95/3C85, 3C96/3C86, 3C96-1/3C86-1, 3C98/3C88, 3C98-1/3C88-1,
3C98-2/3C88-2
3 Application
3.1 Indications for use
The product is to be used exclusively for data communication between an Ottobock product and
the USB port of a PC. The connection from the PC to the Ottobock product is established via a
fibre optics cable.
3.2 Qualification
The product may only be used by persons who have previously been instructed in its proper use.
4 Safety
4.1 Explanation of warning symbols
NOTICE Warning regarding possible technical damage.
4.2 Structure of the safety instructions
NOTICE
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
1. A green LED to indicate operational readiness (correct con­
2
nection to the PC)
2. Red LED to indicate data transfer
3. Fibre optics cable connection
11