Ottobock 60X1 Instrucciones De Uso página 13

NOTICE
Mechanical stress on the product
Limited function due to product malfunction or damage.
► Do not subject the product to mechanical vibrations or impacts.
► Check the product for visible damage before each use.
NOTICE
Use of the product with a damaged USB cable
Malfunction due to incorrect or interrupted data transfer.
► Avoid bending or squeezing the USB cable.
NOTICE
Use of the product with a damaged fibre optics cable
Malfunction due to incorrect or interrupted data transfer.
► Avoid bending or squeezing the fibre optics cable.
► Replace defective or damaged fibre optics cables immediately.
► Do not make any unauthorised changes to the fibre optics cable.
NOTICE
Operating near sources of strong magnetic or electrical interference (e.g. theft preven­
tion systems, metal detectors)
Limited function due to product malfunction.
► Avoid operating the product in the vicinity of sources of strong magnetic and electrical inter­
ference (e.g. high-voltage lines, transmitters, transformer stations, computer tomographs,
magnetic resonance tomographs, etc.).
► Use the product only in orthopaedic workshops, or during in-patient stays in rehabilitation
facilities.
NOTICE
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth
devices, WiFi devices)
Product malfunction due to interference during data transfer.
Therefore, keeping the following minimum distances to these HF communication devices is
►
recommended:
• Mobile phone GSM 850 / GSM 900: 0.99 m
• Mobile phone GSM 1800 / GSM 1900 / UMTS: 0.7 m
• DECT cordless phones incl. base station: 0.35 m
• WiFi (routers, access points ...): 0.22 m
• Bluetooth devices (third-party products not approved by Ottobock): 0.22 m
NOTICE
Operating the product very close to other electronic devices
Limited function due to product malfunction.
► Do not stack the product during operation nor operate it in the immediate vicinity of other
electronic devices in operation.
► If simultaneous operation cannot be avoided, monitor the product and verify proper use in
the existing setup.
13