Zeroing On K16I And K18I; Zeroing The Elevation Dial On K312I, K318I, K525I, K624I And K1050 Moak - KAHLES K4i Manual De Instrucciones

6.1 Zeroing on K16i and K18i

Once you have aligned the scope to the rifle, you can
retain this basic setting. The scale for this is located on the
index disc of the elevation/windage adjustment turret.
1. Hold the turret with your
fingers
2. Use a coin or an empty
cart ridge case and turn
the locking screw (1) in
counter clockwise direc-
tion
3. Loosen the locking screw
till you get a free moving index disc (3)
4. Turn the index disc/ring (3) until the zero point of the
scale is aligned with the index point on the scope
5. Hold the index disc/ring (3) and the turret disc (2) turn
the locking screw clock wise in right direction. While
performing this process you should hear no mechanical
click.
6. Your adjustment is now zeroed to your point of impact.
Pay attention, never use any strong force when you do any
adjust ments on the turrets.
6.2 Zeroing the elevation dial on K312i, K318i,
K525i, K624i and K1050 MOAK
Using the supplied allen key, loosen the two set screws on
the turret 1– 3 turns (do not
remove the
completely) until you have a
free moving turret without clicks.
With the set screws loosened
turn the elevation turret in the
down direction (the direction of
bullet impact is engraved on
set screws
1
2
3
symbolic picture
symbolic picture
23
E