Zeroing The Elevation Dial On K1050 / K1050I Ft; K1050 / K1050I Ft - KAHLES K4i Manual De Instrucciones

6.3 Zeroing the elevation dial on K1050 / K1050i FT

Using the supplied allen key loosen the two set screws on
the turret 1– 3 turns (do not remove the set screws com-
symbolic picture
lines up with the indicator mark on the body tube. Align the
marks and use the short end of the supplied allen key to
tighten the two set screws to approximately 1 Nm or 8 inch
pounds. Your elevation is now zeroed.
Pay attention, never use any strong force when you do any
adjust ments on the turrets.
6.3 a Zeroing the windage dial on K1050 / K1050i FT
symbolic picture
E
Your windage is now zeroed.
Pay attention, never use any strong force when you do any
adjust ments on the turrets.
26
pletely) until you have a free
moving turret without any
clicks. With the set screws
loosened turn the elevation
turret in the down direction
(the direction of bullet impact
is engraved on the adjustment)
so that the zero on the dial
With the rifle and scope sighted in to
the desired point of impact loosen the
two set screws on the windage adjust-
ment dial 1– 3 turns (do not remove
the set screws completely) and move
the dial to align the zero mark to the
indicator mark on the body tube. Using
the short end of the supplied allen key,
tighten the
approximately 1 Nm or 8 inch pounds.
two set screws to