Zeroing The Windage Dial On K312I, K318I; K525I, K624I And K1050 Moak - KAHLES K4i Manual De Instrucciones

the adjustment) until it stops. This will be 3 or 4 marks below
the zero mark on the dial. Turn the turret so that the zero on
the dial lines up with the indicator mark on the body tube.
Align the marks and using the short end of the supplied
allen key tighten again the two set screws to approximately
1 Nm or 8 inch pounds. Your elevation is now zeroed.
The zero stop is sited 3 or 4 clicks below the Zero indicator.
This feature facitilitates the user finding the Zero indicator
quickly and intuitively even in poor light conditions and
adapting the turret to special conditions such as for
example very high temperatures or closer targets.
Pay attention, never use any strong force when you do any
adjust ments on the turrets.
6.2 a Zeroing the windage dial on K312i, K318i,

K525i, K624i and K1050 MOAK

With the rifle and scope sighted in to the desired point of
symbolic picture
pounds. Your windage is now zeroed.
E
Pay attention, never use any strong force when you do any
adjust ments on the turrets.
24
impact loosen the two set screws on
the windage adjustment dial 1– 3
turns (do not remove the set screws
completely) and move the dial to
align the zero mark to the indicator
mark on the body tube.
Using the short end of the supplied
allen key, tight the two set screws
to approximately 1 Nm or 8 inch