Nikon Fun Touch 2 Manual De Instrucciones página 8

L o a d i n g t h e Film
(1) Push the back cover latch in direction of arrow and pull open the cover.
(2) Insert the bottom of the cartridge into the bottom of the film chamber, then
lower the other end in and snap into position.
(3) Pull the film leader across and align it with the yellow film illustration,
shown on the left hand corner of the take-up spool. Be careful not to let the
leader extend too far beyond the yellow illustration, as it may cause
excessive film slack. Make sure film rests flat between the guides and over
the teeth of the sprockets. (Fig. D, E)
(4) Close the back cover until you hear a click, indicating that it is securely
locked. If the cover does not close properly with the film in place, check to
make sure that it is lying flat between the guides and the cartridge is snug in
the chamber.
(5) After the cover is closed, depress the shutter release button and advance
the film until the number " 1 " appears in the frame counter window.
NOTE: The counter will only work with film properly installed in the camera. If
film counter will not advance, repeat steps (1) to (5).
—A—