Reliable Steamboy T2 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The LED will illuminate when the steamer is connected to power outlet.
Please wait for 20 seconds (heat up period) before pressing the steam
release button. Your Steamboy T2 is now ready for use.
NOte: It is recommended that another high wattage appliance is not
operated on the same circuit to avoid a circuit overload.
press the sweeper button located on the base to turn the sweeper on/off.
pass over the area to be swept using a forward motion.
Slowly pass over surface to be cleaned while pressing the steam release
button to emit steam. Hold the steam switch as you are cleaning for periods of
up to 3-5 seconds only. Holding the steam switch continuously will cause the
unit to release water. It is recommended that you sweep the floor prior using
the steamer.
CaUtION: to sanitize an area of your floor, leave the steamer over area for
a minimum of 3 seconds, but no longer than 5 seconds. Leaving the
steamer stationary for a longer period than recommended may cause the
build up of a pale residue. this residue can be removed by using a
decalcifying product or with a few drops of vinegar.
waRNING: Never run the Steamboy t2 without water. Never direct steam at
any person or animal. Use on SeaLeD HaRD FLOOR ONLy.
When steamer runs out of water it will stop emitting steam. Simply remove
the water tank, refill, and continue cleaning.
Change the microfiber pad on the steamer base ocasionally while cleaning to
prevent excess moisture from remaining on the floor.
The carpet glide attachment will assist with freshing and sanitizing the
surface of carpets and area rugs. It is not intended to deep clean or lift dirt
from the carpet.
When you finish your cleaning, unplug the power cord from outlet, empty the
water tank, carefully remove the pad from steamer head, wind power cord
around the cord wrap
Carefully pull the dust bin out of the base and empty the contents into a
trash bin. Then place the dust bin back into the unit.
Over the course of time, hairs, threads and other particles may accumulate
on the rotating sweeper brush. It is advised that these be removed for
optimum functionality.
Store it upright in a dry area or hang by the storage hook.
CaUtION: the microfiber pad may be very hot.
NOte: If you have hard water ensure that the anti-scale cartridge is changed
regularly (at least every six months). Replace it more often if your water is
very hard (ie: well water).
9

Publicidad

Tabla de contenido
loading

Tabla de contenido