Reset [Reset] - OHAUS YS Serie Manual De Instrucciones

EN-4 YS Series Balances
4. MENUS
The menu allows the user to calibrate the scale and to customize scale settings.
To enter the menu, press and hold TARE/On/Yes button. To enter the Calibration
menu, release the button when CAL is displayed. To enter the Setup menu, continue
holding the button and release it when SEtUP / rESEt is displayed.
Note: The Calibration Lockout Switch must be in the "UNLOCK" position to enter the
Calibration menu.
4.1 Calibration Menu [CAL]
Upon entering the Calibration menu, the Calibration Weight setting is displayed.
Press Yes to accept the setting or press No to change the setting.
TABLE 2-1. CALIBRATION WEIGHTS.
Model YS202 YS302 YS601 YS1101 YS2101 YS5001
Default Calibration Weight 200 g 300 g 600 g 1000 g 2000 g 5000 g
Alternate Calibration Weight 100 g 100 g 300 g N/A 1000 g N/A
When the desired Calibration Weight setting is displayed, press Yes. The display
flashes 0, momentarily. Then the display flashes the Calibration Weight value.
Place the Calibration Weight on the pan. When the display stops flashing,
calibration is completed and the scale returns to the weighing mode.
Note: To prevent unauthorized calibration, position the Calibration Lockout Switch in
the "LOCK" position.
4.2 Setup Menu [SEtUP]
To navigate through the Setup menu, press Yes to view the setting for the menu item
or press No to move to the next menu item. When viewing the setting, press Yes to
accept the setting, or press No to change the setting.

RESET [rESEt]

Reset the Setup menu to the factory defaults.
no = not reset
Yes = reset
UNIT SELECTION [SEL]
Set the status of each weighing unit.
OFF = unit is disabled
On = unit is enabled