Parameter Setting (Setup) From Panel - ITALFARAD PFC96evo Manual De Instrucciones

To access the programming menu (setup) :
 To enter parameter programming the unit must be in TEST mode (first programming)
E
N
or in MAN mode.
 From the normal measurement display, press and hold
main menu. SET is displayed on the main display.
 If you have set the password (P.21 = ON) instead of SET the display shows PAS (password
entry request). Set the numeric password using
to next digit.
 If the password is correct the unit will show OK U or OK A depending on the entered pass-
word is user or the advanced level. The password can be defined with parameters P.22 and
P.23. Factory default is 001 and 002 respectively.
 If the entered password is wrong the unit will show ERR.
 After having entered the password, the access is enabled until the unit is re-initialized or for
2 minutes without pressing any key.
 After having entered the password, repeat the procedure to access the parameter setting.
 Press
on the alphanumeric display.
Tel.+39 051 6618311 Fax +39 051 6605594 E-mail: italfarad@italfarad.com Web: www.italfarad.com

Parameter setting (SETUP) from panel

Indication
of TEST
mode
Firmware
revision
MAN
mode icon
Tot kvar
inserited in
MAN
to select the desired submenu (BAS ADV ALA ... ) that is shown
ITALFARAD S.p.A. via IV novembre n.1 Minerbio Bo Italy
Total
number
of steps
Model
variant
Connected
steps
Manual
step
selection
enabled
for 3 seconds to recall the
and then press to move
44