Assembling The Leg Stand - RIDGID R4513 Manual Del Operador

ASSEMBLY

ASSEMBLING THE LEG STAND

See Figures 7 - 12.
Many of the leg stand parts are movable. All hardware must
be tightened securely but not so tight that the leg stand won't
open and close. For easier assembly, match letter to letter
and fingertighten all fasteners. Only tighten fasteners securely
when you are sure the release lever locks over the stop pin.
 Align handle with holes in the end of the upper tube and
insert. Secure in place using a screw and lock nut. Repeat
for other side.
 Place the center brace on top of the inner leg assembly
(curve side up) with the stop pin under the pedal assembly
latch.
NOTE: The stop pins rest on top of inner leg assembly.
 Insert a carriage bolt through the top hole of the inner leg
assembly then slide a large spacer on the bolt. Repeat
for the other side.
 Slide the center brace onto the bolt and secure in place
using a lock nut. Repeat for the other side.
LETTERS
SCREW
Fig. 7
STOP PIN
15 − English
LOCK
NUT
CENTER
BRACE
LOCK
NUT
INNER LEG
ASSEMBLY
UPPER
TUBE
HANDLE
Fig. 8
LARGE
SPACER
CARRIAGE
BOLT
Fig. 9