RIDGID R4513 Manual Del Operador página 29

OPERATION
 Using a sharp pencil, mark a line on the disc at the edge
of the freshly cut wood.
NOTE: These lines indicate the path of the cut made by
the saw blade. When the blade is changed, these lines
will need to be erased and reset.
 With the miter gauge in the right miter gauge groove,
follow the above procedures and make a second mark
on the disc.
TO SET THE RIP FENCE INDICATOR TO THE
BLADE
See Figure 40.
Use the indicator on the rip fence to position the fence along
the scale on the front rail.
NOTE: The anti-kickback pawls and blade guard assembly
must be removed to perform this adjustment. Reinstall the
blade guard assembly when the adjustment is complete.
 Unplug the saw.
 Place the rip fence on the saw table so that it lightly
touches the right side of the saw blade. Lock the rip fence
in place.
 Loosen pan head screws and adjust the indicator so that
the red line is located over the "zero" line on the right rip
scale on the front rail. Retighten screws.
TO USE THE RIP FENCE
See Figures 41 - 42.
 Place the front of the rip fence on the front rail.
 Lower the back end of the rip fence onto the back rail.
 Check for smooth gliding action.
 Position the rip fence the desired distance from the blade.
 Push the locking lever down to automatically align and
secure the fence. When securely locked, the locking lever
should point downward.
Check for a smooth gliding action. If adjustments are needed,
see To Check and Adjust the Alignment of the Rip Fence
in the Adjustments section of this manual.
29 − English
IND-I-CUT
INDICATOR
BACK
RAIL
™
Fig. 39
PAN HEAD
SCREW
Fig. 40
BACK OF
RIP FENCE
Fig. 41