Use & Maintenance - branatech PAC12-12-276 Manual Del Usuario

Safety instructions
•
Special note: if there is a cord damage, in order to avoid danger, it must be replaced by the
maintenance department or other professionals of the manufacturer.
•
Please use three grounding plugs.
•
Do not remove the ground jack.
•
Don't use adapters.
•
Please use air conditioning extension line.
Use advice
•
There is a compressor in the body, if dumping or long-distance transportation, please put
the machine upright for more than six hours, so that the condensate fully reflux, and then
turn the power on.
•
In order for the air conditioner to operate effectively, please ensure that the machine does
not block fifty centimeters in front and behind, in order to facilitate the flow of air.
•
When the temperature is above 43 centigrade or below 15 centigrade, the cooling function
can not be used due to the machine will be self protected .
•
Once the machine stops, restarts, or changes the mode of operation, you will have to wait
for three minutes before you proceed to the next operation.

In the absence of opening timing or sleep mode, the power is interrupted and set up
again, the machine will turn on automatically without pressing the button.

In the situation of timing function or sleep mode open, after power failure, you need to
press the button to boot, after the boot, according to the previous mode of power failure
before operation.

After the normal shutdown, no matter whether the power is interrupted or not, it will re-
member the last mode of operation.
Drainage method
In extreme high temperature, high humidity or heating mode, water tank will be full and
manual drainage or continuous drainage is necessary.
When the water full indicator light and display "E4", remind you to drain.
Turn off the power, move the machine to the proper position, remove the bottom stopper,
and clean the water.
You can also connect the drain pipe to the bottom drain for continuous drainage.
Please use the bottom drain to drain.
Machine maintenance
•
Turn off the machine before turning off the power.
•
If the machine is dirty, wash with warm water and wipe the surface with a soft, dry cloth.
•
Do not use volatile gases such as gasoline or polishing powder to clean the machine.
•
Do not sprinkle water onto the machine.
USE & MAINTENANCE
24