Troubleshooting - Ryobi P2807 Manual Del Operador

Cleaning the nozzles:
 If the nozzles becomes clogged, remove the nozzle
selector.
 Soak entire nozzle selector in warm soapy water.
 If clogs persist, follow the instructions above for removing
nozzles.
 Soak the nozzles in warm, soapy water then blow out
with pressurized air to remove blockage.
PROBLEM
Unit has trouble priming / doesn't
spray when tank is filled.
Unit sprays improperly.
Unit is "spitting".
Spray is weak.
Unit runs for a short period
then shuts off.
This product has a Three-year Limited Warranty
for residential and commercial indoor and outdoor use.
For warranty details, visit www.ryobitools.com
MAINTENANCE

TROUBLESHOOTING

POSSIBLE CAUSE
Pump has lost its prime.
Nozzle is clogged nozzle,
hose is partially disconnected,
or fluid in tank is low.
Liquid in tank is too thick.
Filter needs to be cleaned.
Solution is too thick.
Battery needs charging.
Solution is too thick.
or call (toll free) 1-800-525-2579.
11 — English
When not properly cleaned, the sprayer nozzles may develop
residual chemical build up. This could result in decreased
pressure and spray patterns.
To reduce the chance of blockage, spray a tank of water
through the unit after each use to rinse out any residual
chemical build up that may have occurred.
SOLUTION
Turn the nozzle selector dial to the largest micron setting.
Once spray begins, release the switch trigger and rotate
the nozzle selector dial to the desired position.
Rotate to a different nozzle. If that solves the issue then
clean out the previous nozzle. Check hose connections
and make sure there is sufficient fluid in the tank.
Empty the tank, clean both the tank and filter, then try
again. Make sure that all chemicals/liquid used in the
sprayer are as thin as water.
Clean filter as described in Cleaning the Unit.
Make sure that all chemicals/liquid used in the sprayer
are as thin as water.
Recharge the battery.
Make sure that all chemicals/liquid used in the sprayer
are as thin as water.