Siemens SITRANS Probe LU Manual Del Usuario página 11

Changing a Parameter Value
Notes:
• Security must be disabled to enable programming: set P000 to the Unlocked Value stored
in P069. (A remote master can still change configuration, if P799 is set to allow this.)
• Invalid entries will be rejected or limited.
• CLEAR can be used to clear the field.
1. Key in the new value.
2. Press ENTER
Parameter Reset to Factory Default
1. Scroll to the parameter or enter its address.
Press CLEAR
2.
Master Reset (P999)
Returns all parameters except P000 and P069 to default settings. (The learned TVT curve is not
lost.)
1. Press PROGRAM
2. Press DISPLAY
3. Key in 999.
Press CLEAR
4.
reset. The LCD displays C.ALL.
5. Reset complete. (Reset takes several seconds to complete.)
Quick Setup: steps 1 to 10
Note:
Default values (factory settings) are marked by an asterisk (*) in the tables.
1. Select language (P010: Language)
Numeric/None
0 *
English
1
German
Values 2
French
3
Spanish
4
7ML19985QR81
to set the value.
then ENTER
. The value returns to the default setting.
then DISPLAY
,
to open parameter fields.
then ENTER
, to Clear All and initiate
ENGLISH
P000 LOCK
P001 OPERATION
P003 MEAS RESP
P004 ANTENNA
P005 UNITS
P006 EMPTY
P007 SPAN
P010 LANGUAGE
SITRANS Probe LU – QUICK START MANUAL
to activate PROGRAM mode.
DEUTSCH FRANÇAIS
VERRIEGELG VERROUIL
BETRIEB FONCTIONMT
REAKTIONSZ TEMPS REP .
ANTENNE ANTENNE
EINHEIT UNITES
MESSBER. VIDE
MESSSPANNE PLAGE
SPRACHE LANGUE
ESPAÑOL
BLOQUEO
FUNCIONAM.
TIEMPO R.
ANTENA
UNIDADES
VACIO
RANGO
IDIOMA
Page EN-9