U S E - BDS Maschinen MAB 150 Instrucciones De Manejo

U s e

R e m o v i n g t h e t o o l
Extend the tool mount (2) with the
‹
hand lever (6) until both Allen screws
in the tool mount (2) are freely
accessible.
Loosen both Allen screws in the
‹
tool mount (2) using the SW 4 offset
screwdriver supplied.
Take out the core drill (1) from below.
‹
1 6
U s e
A c t i v a t i n g / d e a c t i v a t i n g t h e
m a g n e t i c c l a m p
CAUTION
D a m a g e t o p r o p e r t y !
To avoid damage to the machine by
overheating of the magnets:
► Only switch on the magnetic clamp
when the machine is on a magnetic
surface.
A c t i v a t i n g t h e m a g n e t i c c l a m p
Switch on the magnetic clamp with the
‹
switch (10). The indicator lamp in the
switch (10) lights up.
NOTE
► The maximum magnetic clamping
force is only available after switching
on the motor.
D e a c t i v a t i n g t h e m a g n e t i c c l a m p
Hold the handle tightly (5) to stop the
‹
machine from slipping.
Switch off the magnetic clamp with the
‹
switch (10). The indicator lamp in the
switch (10) extinguishes.
M A B 1 5 0