BDS Maschinen MAB 150 Instrucciones De Manejo página 13

NF m e t a l s o r w o r k p i e c e s w i t h a n u n e v e n
s u r f a c e
A special holding device must be used
when drilling into NF metals or into
workpieces with an uneven surface.
NOTE
► CS Unitec offers a range of
accessories with special clamping
devices for tubes and non-magnetic
materials.
In s e r t i n g t h e t o o l
The machine is equipped with a
3/4" Weldon (19mm) tool mount that can
accommodate core drills up to a length of
1-3/16" (30 mm).
Only use tools with the corresponding 3/4"
(19 mm) Weldon shank.
W A R NING
R i s k o f i n j u r y !
► Do not use damaged, soiled or worn
tools.
► Change tools only when the machine
is switched off and at a standstill.
Disconnect the voltage supply.
M A B 1 5 0
W A R NING
R i s k o f i n j u r y !
► After inserting, check that the tool is
engaged securely.
► Only use tools, adapter and
accessories that match the machine.
In s e r t i n g t h e c o r e d r i l l
Before mounting, clean the Weldon
‹
shank of the core drill and tool mount (2)
of the machine.
Check the supply connection for
‹
the lubrication (hose of the pump
bottle (C) must be attached to the
connecting nipple (4)).
Extend the tool mount (2) with the
‹
hand lever (6) until both Allen screws
in the tool mount (2) are freely
accessible.
Loosen both Allen screws in the
‹
tool mount (2) using the SW 4 offset
screwdriver supplied.
NOTE
► Insert the appropriate ejector pin (A)
before inserting a core drill.
Insert the core drill (1) from below
‹
into the direct tool mount (2) of the
machine.
Tighten both Allen screws in the direct
‹
tool mount using the SW 4 offset
screwdriver supplied
W A R NING
R i s k o f i n j u r y f r o m
t o o l !
► Check for secure and correct seating
of the core drill.
P r e p a r a t i o n
i n c o r r e c t l y i n s e r t e d
1 5