Aroma Function - Krups KM4 Serie Manual De Instrucciones

DahlstromRéf. NC00020545-02_DahlstromRéf. NC0020545-02 11/10/13 09:52 Page12
The display will show logos with the current time.
Regular
If you wish to activate the Aroma Function on your automatic brewing program, press
the AROMA button (q). The cup of coffee icon will become black to alert you that the
aroma function has been set-up.
Strong
Press PROG (r) when done.
2- Auto-On setting #2:
Press PROG (r) twice, the AUTO program #2 is indicated with a red light (o).
This second preset start time can be used for days with later wake times, ie weekends.
Press the auto-on button (n) to choose preset number 1 or number 2. The auto-program 1
or auto-program 2 red light will switch on, and indicates you that an automatic program has
been set up. You can check the preset times by pressing PROG (r).
After programming the automatic start time as described above, be sure to prepare the
machine for a brew cycle with water in the tank, coffee in the brew basket, lid closed
and carafe securely in place.
The machine will brew automatically at the designated time. The program will need to
be activated when needed again.
3- Auto-Off setting (only for model
with glass carafe):
Press PROG (r) 3 times, the number of hours will blink and the 2 red lights (o) on the
control panel will blink.
Use the H button (p) to change between 1, 2 or 3 hours.
Press PROG when done.
This function controls how long the heating plate will continue before automatically
turning off. For best results we recommend brewing only as much coffee as you will
consume in 30-60 minutes. Taste is affected the longer the coffee is allowed to sit on
the heating plate.
AROMA FUNCTION
This function is designed specifically for small batches, normally less than 6 cups, where brew
cycles become too short to properly extract the coffee taste from the coffee ground.
To activate press the Aroma button (q), then press On.
Note : this function cannot be changed once the brew cycle has started.
12
English