Garant 23 7502 ER25 Manual De Instrucciones página 14

All of the assembled tools displayed are shown in basic setting 0.
When fitting the tool, the indexable insert must point in the direction of the positive adjustment
direction (+) of the slider.
DE DE
Fit cartridge H1 or H2 , adjust using graduated scale and fasten to 5 Nm using cheese-head screw 2
(spring disc/plain washer).
Loosen screw A.
Place tool on pre-setting device: adjust finely using graduated dial.
Here, one turn of the graduated dial corresponds to an ⌀-adjustment of 1 mm.
Using the scale, adjustments of 0.01 mm can be made from graduation to graduation or of 2 μm using
the vernier.
Clamp slider B to 4 Nm with screw A.
EN
FR FR
IT IT
ES ES
14