Unpacking And Assembly; Assembling The Extendable Shaft - Oregon PS250 Manual De Instrucciones

Unpacking and Assembly

Unpacking
What's in the box?
The pole saw requires some assembly before
use These items ship with the pole saw:
• Powerhead
• Extendable shaft with attached cutting head
• Guide bar
• Saw chain
• Blade cover
• Harness
• Screwdriver
• Allen wrench
• Two Allen screws
• Bar and chain oil
• Charger and power cord (if so equipped)
• Battery (if so equipped)
After removing the pole saw from the box,
inspect it carefully to ensure no damage has
occurred during shipping, and that no parts are
missing If any parts are damaged or missing,
do not use the pole saw Contact Oregon®
Cordless Tool System at 888 313 8665 to obtain
replacement parts
16
Unpacking and Assembly
Assembly
DANGER: To avoid serious personal
injury, do not operate the pole saw without
the extendable shaft, guide bar, saw chain,
and side cover properly assembled.
WARNING: A battery operated tool with
the battery pack inserted is always on and
can start accidentally. Remove the battery
pack from the pole saw before attaching
the extendable shaft, bar, and chain.

Assembling the Extendable Shaft

The extendable shaft fits into the motor
housing on the powerhead (Fig 6)
FIG. 6
• It is important to ensure that the internal
drive shaft is properly seated To ensure
proper seating, use a clean rag to pull the
aluminum drive shaft out from the fiberglass
pole—approximately 10 in (25 cm) Using the
rag, turn the aluminum shaft while pushing
down slightly This will allow the drive shaft to
properly seat on the shaft inside of the motor
housing The cylindrical end of the drive shaft
will be completely hidden below the rim of the
motor housing once properly seated
Pole Saw Model PS250