Filling The Bar And Chain Oil Reservoir - Oregon PS250 Manual De Instrucciones

• After properly seating the aluminum drive
shaft, push down on the fiberglass pole so
that is slides into the opening of the motor
housing
• Locate the provided Allen screws and place
them into the holes on the red cap The red
cap on the motor housing acts as compression
fit to hold the pole in place
• Use the supplied 4 mm Allen wrench to
partially tighten the Allen screws Continue
tightening the screws by alternating between
screws until both of the screws are tight
Note: You may need to press the red cap
tighter onto the motor housing to allow the
screws to make contact with the internal
threads
Pole Saw Model PS250
Unpacking and Assembly
Filling the Bar and
Chain Oil Reservoir
IMPORTANT: Bar and chain oil prevents
premature wear. Never operate the pole
saw if oil is not visible. Check oil level
frequently and fill as needed.
Bar and chain oil is required to properly
lubricate the guide bar and saw chain The
pole saw is equipped with an automatic oiler
that deposits oil on the bar and chain when
running, keeping them properly lubricated Use
Oregon® bar and chain oil for best results It is
specially designed to provide low friction and
faster cuts NEVER use oil or other lubricants
not specifically designed for use on the bar and
chain This can lead to a clogged oil system,
which may cause premature wear of the bar
and chain
• Place the pole saw on its side on a firm, flat
surface, so that the oil cap is on top (Fig 7)
FIG. 7
• Clean any debris from the cap area
• Remove the cap
• Carefully pour the bar and chain oil into the
reservoir
• Replace the cap and make sure oil is visible in
the reservoir
If oil is not visible in the reservoir, additional bar
and chain oil is necessary
17