Manual Code Search - MELICONI SPEEDY 210 COMBO Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
WARNING - separate data with a comma, and be as precise as possible so that the information system can search
for data and answer correctly.
Send the SMS to 0039 345 7518893 and wait for a reply by SMS.
After receiving the code list by SMS, set the fi rst code on the remote control as described in the ENTERING THE CODE
DIRECTLY procedure.
Stand in front of the device already turned on with the MELICONI remote control and press the ON/OFF button. If the
device does NOT turn off, try to set the next code on the SMS list on the remote control. Repeat the operation until
the device responds. When the device responds, confi rm that the other buttons are also operating correctly. If so, the
remote control is ready to use. Otherwise, an inaccurate code, used for a very similar device, is being entered; ignore
the SMS list and see paragraph MANUAL SEARCH to identify a more suitable code.
NOTE: If no SMS is received on the mobile phone or if the message ERROR / NO CODE is displayed,
the system was not able to process the data; do not attempt to send it again and only use the MANUAL SEARCH to
set the code.
D
(only to be performed if the specifi c code could not be found)
If you want to use the Speedy 210 combo to simultaneously control two different devices (TV + DECODER) follow
procedure D1 then procedure D2.
To control a single device (DECODER), follow only procedure D2.
To control a single device (DIGITAL TV), follow procedure D3.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN USE
procedure and make a note of it inside the battery cover.
1. Look for the brand of the device that you want to control
in the TV column of table at the beginning of the booklet
and make a note of the number in the BUTTON column
(e.g. PHILIPS TV = 6). If the brand is not present, use "0".
2. Stand in front of the device you wish to control.
3. Make sure that the device is switched ON (not in stand-
by). If necessary, switch it on using the original remote
control unit (if this is still working) or the buttons present
on the device itself (these may be located on the side or
top of the device, depending on the brand and model).
4. Press and hold the volume + and volume - buttons on
the Meliconi remote control unit simultaneously for 6
seconds.
5. Release the buttons. The indicator lamp will start to fl ash
more rapidly. Press the button corresponding to the
number identifi ed in the table momentarily.
6. KEEP THE REMOTE CONTROL UNIT POINTED towards
the device you wish to control.

MANUAL CODE SEARCH

D1. MANUAL SEARCH (TV)
SONY
SAMSUNG
PANASONIC
METRONIC
SHARP
DIGIQUEST
PHILIPS
STRONG
TELEFUNKEN
HUMAX
MIVAR/UNITED
ID SAT/ZODIAC
6

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido