MELICONI SPEEDY 210 COMBO Instrucciones De Uso página 13

7. PRESS AND HOLD the TV OFF button on the MELICONI
remote control unit.
IMPORTANT!: The search process may take several
minutes
8. When the device switches off, RELEASE the button
IMMEDIATELY and PRESS the OK button.
Three long fl ashes indicate that the operation has been
completed successfully.
Check that the other buttons (light blue) correspond to the functions of the original remote control; if not,it is
likely that the code found is incorrect, but is used for a very similar device, therefore repeat the procedure
1. Look for the brand of the device that you want to control
in the STB column of table at the beginning of the booklet
and make a note of the number in the BUTTON column
(e.g. SAMSUNG STB = 3). If the brand is not present, use
"0".
2. Stand in front of the device you wish to control.
3. Make sure that the device is switched ON (not in stand-
by). If necessary, switch it on using the original remote
control unit (if this is still working), or the buttons present
on the device itself.
4. Press and hold the P + and P - buttons on the Meliconi
remote control unit simultaneously for 6 seconds.
5. Release the buttons. The indicator lamp will start to fl ash
more rapidly. Press the button corresponding to the
number identifi ed in the table momentarily.
6. KEEP THE REMOTE CONTROL UNIT POINTED towards
the device you wish to control.
7. PRESS AND HOLD the STB ON/OFF button on the
MELICONI remote control unit.
IMPORTANT!: The search process may take several
minutes
8. When the device switches off, RELEASE the button
IMMEDIATELY and PRESS the OK button. Three long
fl ashes indicate that the operation has been completed
successfully.
from point 2.
D2. MANUAL SEARCH (DECODER)
BUTTON TV
STB
SAMSUNG
LG
SONY
PANASONIC
SHARP
STB
TV
TER/SAT
ADB / SKY
TELESYSTEM
SAMSUNG
METRONIC
DIGIQUEST