Datalogger Function - Promax PROLINK-4C Manual De Instrucciones

USER'S MANUAL. PROLINK-4C
4.9.4.4

Datalogger Function

The Datalogger function allows the user to carry out, store and/or print out up
to 9801 measurements in a fully automatic way. It may be understood as a
measurement matrix whose columns address the 99 measuring configurations (defined
in the 99 memories of the equipment) and whose lines permit to store 99 measurements
for every measuring configuration (conducted in different points of the system or in the
same point on different times).
Before to proceed to take measurements by means of the Datalogger function
it is necessary to store the measuring configuration/s in the memory by using the Store
function (see paragraph 4.12.1).
To select the Datalogger function activate the TV mode functions menu, by
pressing the rotary selector [4] when in the TV operation mode. Then, turn the rotary
selector [4] to the Datalogger field and press it, the DATALOGGER screen will appear
automatically.
As you can see in the previous figure, the main screen of the Datalogger
function has three functions: Config (Configuration), Run and Exit. Below these three
functions is the measurements matrix, three columns and five rows are simultaneously
displayed (in the previous figure the datalogger has three stored measurements, one for
each of the first three memories).
To access the various screen functions or fields press key
02/2003
Figure 30.- DATALOGGER screen.
[31] repeatedly.
Page 61