Safety Devices; Controls, Indicators And Connections; Inspections Prior To Starting; Starting/Stopping The Vacuum Cleaner - Nilfisk VHS110N1 CR Manual De Instrucciones

VHS110N1 CR

Safety devices

1.
Cover
2. Cooling air HEPA filter
3. Motor

Controls, indicators and connections

1. Container release handle
2. Swivel caster with brake
3. PullClean filter cleaning system
4.
Vacuum gauge
5. Manual motor starter
6. Band latches
7. Power supply cord
8.
Push bar handle

Inspections prior to starting

1. Inlet
Prior to starting, check that:
■ The filter is installed;
■ All latches are tightly locked;
■ The vacuum hose and tools have been correctly fitted
into the inlet (1).
■ The polyliner is installed (if applicable)
■ The floater inside the liquid container is present and
correctly installed (if applicable)
Do not use the device if the filter is faulty.
US
C424
Figure 4
Figure 5
Figure 6
WARNING!

Starting/stopping the vacuum cleaner

WARNING!
Lock the caster brakes (1) before starting the vacuum
cleaner.
Standard version
■ Turn the manual motor starter (2) to the "I" position
to start the vacuum cleaner. Turn the manual motor
starter (2) to the "O" position to turn the vacuum cleaner
off.
Liquid vacuum stopping
■ When the tank is full, the float (9 Fig.1) stops the
vacuuming operation; the vacuum units remain activated.
■ Switch off the vacuum units by pushing the switches (5
Fig.5).

Vacuum cleaner operation

Vacuum gauge (2): green zone (3), red zone (1)
Check the flow rate:
■ when the vacuum cleaner is operating, the pointer of
the vacuum gauge must remain in the green zone (3)
to ensure that the speed of the intake air does not drop
below the safety value of 3937 ft/min (20 m/s);
■ if the pointer is in the red zone (1) it means that the
speed of the air in the vacuum hose is less than
3937 ft/min (20 m/s) and that the vacuum cleaner is
not operating optimally. The filter must be shaken or
replaced.
■ during normal operation conditions, close the vacuum
hose, the pointer of the vacuum gauge must switch from
the green zone (3) to the red zone (1).
WARNING!
When the vacuum cleaner is operating, always check
that the vacuum gauge pointer remains in the green
zone (3).
Consult the "Troubleshooting" chapter if faults occur.
8
Figure 7
Figure 8
04/2016