Meccanica Benassi Daytona 2WD Manual De Usuario página 27

(14) CHOKE
For starting a cold engine.
(15) BY-PASS LEVER – FREE MOVEMENT OF THE REAR WHEELS
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or
pull the machine without using the engine. The lever is located on the rear side of the machine and has
the following two positions:
ATTENTION! On the AC 92-23 4x4 machine the lever is used primarily for bleeding the
hydrostatic system. Due to the high demands on equipment, have this procedure performed
by a specialised service centre.
The machine must not be used (gear shifted into drive) if the by-pass lever is in the
disengaged position - there is a danger of damage to the transmissions!
(16) TILTING FRAME CONTROL LEVERS
The folding frame is intended to prevent the machine from rolling over by 180° if for any reason it loses
stability and rolls on to its side. Under no circumstances does the protective frame serve as safety /
protection feature for the operator! The folding frame has 3 positions:
1. Work
2. Maintenance
3. Auxiliary for handling the machine
The individual positions are set using quick coupler levers on the sides of the frame.
CHOKE Starting a cold engine
Position Rear wheel drive
(0) DISENGAGED
(1) ENGAGED
27
Use
Lever is extended - for pushing the
machine
Lever is inserted - for driving the
machine