Replacing A Fuse; Lifting The Machine; Mowing Deck - Checking And Maintenance Of The Mowing Blades; Replacing Blades - Meccanica Benassi Daytona 2WD Manual De Usuario

Ocultar thumbs Ver también para Daytona 2WD:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

6.3.4 REPLACING A FUSE

If a fuse is damaged the engine will immediately shut off, the
mowing deck will stop and all indicator lights on the dash board
will turn off. In this case it is necessary to find the faulty fuse and
replace it with a new one. Under no circumstances should you
replace a faulty fuse with a fuse that has a higher current rating!
 Release the screw holding down the front hood, lift the hood and
remove the protective fuse cover.
 Remove the old fuse and insert a new fuse with the same rating
as the initial fuse, i.e. 20A or 10A.
If even after replacing the fuse the engine or the mowing deck will not work, contact an
authorised service centre.
Under no circumstances should you attempt to remove the control unit of the
electrical system!

6.3.5 LIFTING THE MACHINE

If you wish to lift the riding mower, use a jack and supports.
Proceed as follows:
 Place the jack underneath the gear box on the rear axle and lift the rear part of the machine.
 Insert two supports underneath the ends of the axles from the inner side of the rear wheels.
 Lift the front part of the machine and insert two supports under both ends of the front wheel axles.
Never lean the machine to the side where the carburettor is located. Oil could enter the air
filter!
6.3.6 MOWING DECK – CHECKING AND MAINTENANCE OF THE MOWING BLADES
Before each use of the riding mower check the condition of the blades (damage, wear, condition of the
cutting edge). If the blades are blunt, bent or broken it will negatively affect mowing quality. Damaged
blades are very dangerous.
A part of the material could break off and be deflected from the work area of the machine.
Whenever handling the mowing blades, always use heavy-duty work gloves.

 REPLACING BLADES

If due to frequent use the blades are worn or damaged, they cannot be balanced or sharpened properly,
it is necessary to replace them immediately.
The blades are sharpened from both sides so in the event that one side is blunt, it is possible
to turn the blade around.
37

Publicidad

Tabla de contenido
loading

Productos relacionados para Meccanica Benassi Daytona 2WD

Este manual también es adecuado para:

Daytona 4wd

Tabla de contenido