Manual Loop - Rane Seventy-Two MKII Guía De Usuario

Manual Loop

Manual Loop Mode enables you to return the track to
a loop you created and saved earlier. The pad layouts
for the two banks are identical.
To enter Manual Loop Mode, press Auto Loop /
Man Loop so that it lights green.
To create a loop, press Pad 5 to set the Loop In
point and then press Pad 6 to set the Loop Out point
and activate the loop.
To save a loop, while a loop is active, press an unlit pad in the top row (Pads 1–4). You can do this
regardless of how the loop was created (Auto Loop Mode, Manual Loop Mode, etc.).
To activate or deactivate a saved loop, press a lit pad in the top row (Pads 1–4).
To delete a saved loop, press Shift and a lit pad in the top row (Pads 1–4).
To activate or deactivate the last-activated loop, press Pad 7.
To immediately reactivate the last-activated loop ("reloop"), press Pad 8.
To halve or double the length of a loop, press the Parameter / buttons, respectively.
To shift a loop backward or forward, press Shift and the Parameter / buttons, respectively.
Manual Loop 2
To enter Manual Loop 2 Mode, hold Shift and press Auto Loop / Man Loop (2) so that it lights
yellow. In this mode, Pads 1–4 are used to activate or deactivate Loops 5–8 respectively.
Roll
In Roll Mode, each pad triggers a momentary loop roll. Releasing the pad stops the loop roll and
resumes normal playback where the playhead would be if you had not triggered the loop roll (i.e., as
if the track had been playing forward the whole time).
Note: Disable Show Beat Jump Controls in the Serato Setup menu to access 8 loop rolls at once.
You can also view and edit the set loop sizes in the software.
To enter Roll Mode, press Roll / Pad FX so that it lights aqua.
To trigger a loop roll, press and hold a Pad.
To change which eight lengths for loop rolls are shown (in the software), press either of the
Parameter / buttons. The pad layout will shift to match it.
To shift the loop roll backward or forward, press Shift and the Parameter / buttons,
respectively.
16
2
1
Loop 1 Loop 2
5 6
Set Set
Loop In Loop Out
3 4
Loop 3 Loop 4
7
8
Loop
Reloop
On/Off