Control Panel - Rane Seventy-Two MKII Guía De Usuario

Faders
Seventy-Two MKII's Channel Faders are contactless MAG FOUR faders with adjustable tension.
To adjust the tension on Seventy-Two MKII's
Channel faders:
1. Make sure the unit is powered off and
disconnected from a power source.
2. Using a screwdriver, remove the screws from
faceplate at bottom of the top panel where the
faders are located (see image).
Note: The fader caps must be removed to
remove the faceplate.
3. Using a screwdriver, adjust the tension screw for
each fader to your preference.

Control Panel

The Rane Control Panel allows you to adjust settings
on your Seventy-Two MKII mixer and save and load
these settings to a file (.r72) on your computer. Using
settings files lets you maintain several different control
configurations to use in different situations.
To manage settings files, navigate to the Settings
section of the Rane Control Panel, under the General
tab.
•
Load: Select this to locate and load a Seventy-
Two MKII settings file (.r72) on your computer to
the Control Panel.
•
Save: Select this to save the mixer's settings to
your computer as a Seventy-Two MKII settings
file (.r72).
You can also use the Rane Control Panel to calibrate
the faders on your Seventy-Two MKII:
1. Make sure your Seventy-Two MKII is powered on
and connected to an available port on your
computer using a USB cable.
2. Open the Rane Control Panel.
3. Go to File > Fader Calibration.
4. Follow the instructions on screen to select the
desired fader and calibrate it. You will be
prompted once the calibration is successful.
Top Panel Fader Plate
MAG FOUR Fader Top View
Tension Screw
21