Installation; Assembly And Commissioning; Installation Area; Electrical Connection - Mondolfo Ferro TBE156 PRO Serie Manual De Uso

5 INSTALLATION

CAUTION
When choosing the installation site, com-
ply with the current regulations as regards
safety at work.
Each machine must be installed on a stable,
rigid floor. The spaces necessary for work
must be left.
CAUTION
If the machine is installed outdoors, it
must be protected with a suitable shelter.
Working environment conditions
- Relative humidity: 40 — 95%
- Temperature:

INSTALLATION AREA

An area of 517x635x285 cm is required for
installation of the machine.
From the control position, the operator
has a good view of the machine and the
surrounding area.
He must keep unauthorised persons and
objects which might cause hazards outside
this area.
The machine must be installed on a hori-
zontal surface, preferably on concrete or
ceramic tile coverings.
Avoid loose or unstable surfaces.
The surface on which the machine is instal-
led must withstand the loads transmitted
during operation.
CAUTION
The machine must be fixed to the floor
using screws and screw anchors only if
wheels with weight in excess of 500 kg
are changed.
TBE 156 PRO N - DE LUXE - SUPER
0° — 45°
PROCEDURE FOR INSTALLING
THE SCREW ANCHORS
1 Drill a hole 80 mm deep using a bit ø
16 mm
2 Clean the hole
3 Tap the screw anchors into the hole
hitting them softly with a hammer
4 Tighten the bolts using a torque wrench
set at 45 Nm (if this value cannot be
obtained, this is because the hole is
too large or the concrete is not firm).
6 ASSEMBLY AND
COMMISSIONING
After unpacking the various components
and checking them for damage or any ano-
malies, follow the instructions provided be-
low to assemble the various components.
Tools required for installation:
- 1 screwdriver
- 1 13 spanner
Fasten the control column to the base using
the fixing screws.

Electrical connection

Even small jobs on the electrical
equipment must be performed by profes-
sionally qualified staff.
In standard versions, the machineís power
supply system is THREE-PHASE + EARTH
at 380 V or 220 V or 200 V.
The machine is pre-set in the factory for
the voltage specifically requested by the
customer.
Any change to the power supply voltage
cannot be made by the user; call in the
professionally qualified staff, your dealer
or authorised service centre.
47