Nameplate Data; Routine Maintenance; Troubleshooting Table - Mondolfo Ferro TBE156 PRO Serie Manual De Uso

11 NAMEPLATE DATA

MONDOLFO FERRO S.p.A.
Viale dell'industria n°20
61037 MONDOLFO (PS) ITALY
Tel. 0721-93671 - fax 0721-930248
- CE mark
- year of construction:
- model: TBE 156 PRO N - DE LUXE - SUPER
12 ROUTINE
MAINTENANCE
To guarantee the machineís efficiency and
correct operation, it is essential to comply
with the manufacturerís instructions with
regard to cleaning and regular routine
maintenance.
CAUTION
Cleaning and routine maintenance must
be carried out by authorised personnel in
accordance with the MANUFACTURERís
instructions provided below:
check the tank fluid level; top up if neces-
sary using API CI S32 fluid or an equivalent
check that there is still grease in the re-
duction unit, and add VANGUARD EP-00 or
corresponding grease if necessary.
CAUTION
Any top-ups or fluid changes using fluid
of qualities different from those indicated
may reduce the machineís lifetime and
impair its performance.
Clean all moving parts (jaw unit).
Keep the machine and the working area
clean to prevent dirt from infiltrating wor-
king parts
Grease all parts fitted with grease nipples
regularly.
50
IMPORTANT
The operator MUST NEVER vary the relief
valve trigger pressure value and MUST
NEVER vary the setting value of the pres-
sure limiter.
The manufacturer declines all responsibi-
lity for injury or damage due to failure to
follow this rule.
CAUTION
No maintenance work must be carried out
until the plug has been disconnected from
the electrical mains.
CAUTION
Never clean by blowing with compressed
air.
13 TROUBLESHOOTING
TABLE
PROBLEM
When the control levers are used, the
fuses blow
POSSIBLE CAUSE
1 Power wire connected to earth
2 Inverter has short-circuited
3 Motor has short-circuited
REMEDY
1 Check the wires
2 Replace the inverter
3 Replace the motor
PROBLEM
The bead breaker cylinder force is ina-
dequate
POSSIBLE CAUSE
1 Breakage on gear pump hydraulic line
2 Cylinder seals worn
TBE 156 PRO N - DE LUXE - SUPER