Charging The Internal Battery Of The Booster - Schumacher Electric DSR104 Manual Del Usuario

CHARGER
6.1
Start/Stop Button
Press to immediately begin charging your properly connected battery. If the button is not pressed,
charging should begin in ten minutes.
LED Indicators
POWER (green) LED lit: The charger is connected to AC power.
BAD BATTERY (red) LED: The charger has detected a problem with the battery.
See Troubleshooting for more information.
CLAMPS REVERSED (red) LED flashing: The connections are reversed.
CHARGING (yellow/orange) LED lit: The charger is charging the battery.
CHARGING (yellow/orange) LED flashing: The charger is in abort mode.
CHARGED/MAINTAINING (green) LED pulsing: The battery is fully charged and the charger is in
maintain mode.
NOTE: See Operating Instructions for complete description of the charger modes.
7.

CHARGING THE INTERNAL BATTERY OF THE BOOSTER

• Press the Voltmeter button to show the charge level of the battery.
• After starting the engine at 2000 rpm, leave the booster connected to the vehicle and press the
voltmeter button. The voltmeter will indicate between 14 and 14,4 volts (at 2000 rpm) if the alternator
is functioning correctly.
Grounding and AC Power Cord Connections
7.1
IMPORTANT. Only use the charger that was included with the booster to charge the internal battery of
the booster. Using a different charger could result in personal injury or property damage.
WARNING! RISK OF ELECTRIC SHOCK OR FIRE.
This battery charger is for use on a nominal 120V circuit. The plug must be plugged into an outlet
that is properly installed in accordance with all local codes and ordinances. The plug pins must fit the
receptacle (outlet). Do not use with an ungrounded system.
DANGER. Never alter the AC cord or plug provided – if it does not fit the outlet, have a proper outlet installed
by a qualified electrician. An improper connection can result in a risk of an electric shock or electrocution.
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord
could result in a risk of fire and electric shock. If an extension cord must be used, make sure:
• The pins on the plug of the extension cord are the same number, size and shape as those of the plug on
the charger.
• The extension cord is properly wired and in good electrical condition.
• The wire size is large enough for the AC ampere rating of the charger, as specified:
Length of cord (feet)
AWG* size of cord
*AWG-American Wire Gauge
Charging the Booster
7.2
1. Connect the end of the quick-connect cord to the charger.
2. Insert the charge plug into the charge port on the front of the booster.
3. Plug the charger's power cord into a grounded 120V AC electrical wall outlet.
4. The charger's green Power LED will light.
5. Charging will begin within ten minutes and finish automatically. (Press the Start/Stop button to begin
charging immediately.)
6. The pulsing green LED indicates the battery is fully charged.
7. When charging is complete, disconnect the charger from the AC power. Then remove the charging plug
from the booster.
25 50 100 150
18 18 18 16
• 7 •