Adjusting The Start Address; Dmx Control; Cleaning The Unit; Dmx Channels - IMG STAGELINE PARL-14DMX Manual De Instrucciones

5.3.2 Adjusting the start address

To be able to operate the spotlight with a light con-
troller, adjust the DMX start address for the first
DMX channel. If e. g. address 17 on the DMX con-
troller is provided for controlling the red LEDs,
adjust the start address 17 on the spotlight. Then
the other DMX functions of the spotlight are auto-
matically assigned to the following addresses (in
this example 18, 19, 20 and 21). The address 22
could be used in this example as the next possible
start address for the following DMX-controlled unit.
1) Press the button FUNC (6).
2) Select the function
DOWN and confirm with the button ENT. The
display (5) shows
DMX start address flashing.
3) Use the button UP or DOWN to adjust the
desired start address and confirm with the but-
ton ENT.

5.3.3 DMX control

To be able to operate the spotlight with the DMX
controller, the display must show and behind it the
start address. If not, make the steps described in
chapter 5.3.2 to adjust the start address. To indi-
cate reception of control signals, the
the display.
If the display shows
DMX control mode but no DMX control signal is
present at the jack DMX input (12).

6 Cleaning the Unit

The plastic pane in front of the LEDs should be
cleaned at regular intervals from the outside,
depending on impurities caused by dust, smoke or
other particles. Only this will ensure that the light is
radiated at maximum brightness. For cleaning,
disconnect the mains plug from the socket. Only
use a soft, clean cloth and a mild detergent. Then
wipe the plastic pane dry.
For cleaning the other parts of the housing, only
use a soft, clean cloth. Never use any fluid; it may
leak into the unit and cause damage.
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
with the button UP or
and behind it the present
flashes on
, the spotlight is in the
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
®
7 Specifications
Light source: . . . . . . . . . . 167 LEDs
Diameter: . . . . . . . . . . . 10 mm
Beam angle: . . . . . . . . . 25°
Power supply: . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . 20 VA max.
Ambient temperature: . . . 0 – 40 °C
Dimensions: . . . . . . . . . . . 270 × 210 × 100 mm
Weight: . . . . . . . . . . . . . . 2.2 kg

7.1 DMX channels

DMX value Function
Channel 1
0 – 255 basic brightness of the red LEDs
Channel 2
0 – 255 basic brightness of the green LEDs
Channel 3
0 – 255 basic brightness of the blue LEDs
Channel 4
0 – 255 basic brightness of the white LEDs
Channel 5
0 – 7 light off
dimmer dark → bright
8 – 190
colour mixing via channel 1 – 4
191 – 200 music-depending colour change
stroboscope slow → fast
201 – 247
colours and brightness via channel 1 – 4
no stroboscope
248 – 255
colours and brightness via channel 1 – 4
Subject to technical modification.
Red: 43, green: 44,
blue: 40, white: 40
GB
11