Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6 Switching on /off
Muting
To switch on, press the button POWER /MUTE
(1) briefly The lighting colour of the button indi-
cates the battery status:
green: batteries charged sufficiently
red:
batteries almost discharged
For information on the display indications refer
to chapter 1:
☞
To mute the sound, press the button POWER /
MUTE briefly; the display will briefly indicate
When the sound is muted, the illumi-
nated button and the display backlight start flash-
ing The display will indicate
sound, press the button once again; the display
will briefly indicate
To switch off, keep the button POWER /MUTE
pressed until the display indicates
7 Settings
Use the buttons SET,
settings for the pocket transmitter:
1) To call up the setting mode, keep the but-
ton SET pressed for 3 seconds: The display
indicates
lected ("Selecting a frequency from a group"
or "Setting the frequency directly", whichever
function was used to set the current transmis-
sion frequency)
2) To select a function, use the button SET:
Press the button repeatedly until the desired
function is reached
Overview of functions
1. "Selecting a frequency from a group"
(or "Setting the frequency directly")
2. "Setting the frequency directly"
(or "Selecting a frequency from a group")
3. "Adjusting the sensitivity"
4. "Level attenuation"
5. "Selecting the transmission power"
6. "Key lock"
10
display (3)
To unmute the
and
(4) to make
and the first function is se-
3) To change the setting, use the button
or
When a function offers two setting op-
tions (e g group number and channel num-
ber), use the button SET to go from the first
option to the second option
4) To save the setting, press the button SET
The display indicates
mode is exited
If no setting has been changed when the last
function is reached, the setting mode will be
exited when the button SET is pressed (indica-
tion
)
For detailed information on the functions refer to
the following chapters
7.1 Selecting a frequency from a group
Just like on the receiver US-36G2 /5, the trans-
mission frequency can be selected from one of
the 6 preset groups (overview:
detailed information on this function refer to the
instructions of the receiver
1) The group number (in front of the hyphen)
starts flashing on the display: Use the button
or
to select the group
2) Press the button SET
3) The channel number starts flashing on the
display: Use the button
channel
4) To save the setting, press the button SET
7.2 Setting the frequency directly
Just like on the receiver US-36G2 /5, the desired
frequency can be selected from 1441 available
frequencies
1) The first three digits of the transmission fre-
quency start flashing on the display: Use the
button
or
to set the frequency in steps
of 1 MHz
2) Press the button SET
3) The last three digits of the transmission fre-
quency start flashing: Use the button
to set the frequency in steps of 0 025 MHz
4) To save the setting, press the button SET
and the setting
page 3) For
☞
or
to select the
or
Publicidad
Tabla de contenido
