Hopper Dust Control Filter - Advance CS7010 Instrucciones De Uso

A - ENGLISH

HOPPER DUST CONTROL FILTER

The hopper dust control fi lter must be cleaned regularly to maintain the effi ciency of the vacuum system. Follow the recommended fi lter service
intervals for the longest fi lter life.
CAUTION!
Use only the approved Advance high capacity dust control fi lter in this machine. Use of standard pleated fi lters will result in
insuffi cient air fl ow, inadequate clean shaking, and potential machine damage.
Wear safety glasses when cleaning the fi lter.
Do not puncture the paper fi lter.
Clean the fi lter in a well-ventilated area.
To remove the hopper dust control fi lter:
1. See Figure 21. Unlatch the Hopper Cover
Latches (16) and lift the Hopper Cover.
2. Loosen the two Thumb Nuts (HA), then slide the
Filter Shaker Motor Assembly (HB) to the left and
lift it out of the hopper.
3. Hang the shaker assembly on the hopper cover
Hinge Hook (HC).
4. Inspect the top of the Hopper Dust Control Filter
(17) for damage. A large amount of dust on top of
the fi lter is usually caused by a hole in the fi lter or
a damaged fi lter gasket.
5. Lift the Hopper Dust Control Filter (17) out of the
machine.
6. Clean the fi lter using one of the methods
below:
Method "A"
Vacuum loose dust from the fi lter. Then gently
tap the fi lter against a fl at surface (with the dirty
side down) to remove loose dust and dirt. NOTE:
Take care not to damage the gasket.
Method "B"
Vacuum loose dust from the fi lter. Then blow
compressed air (maximum pressure 100 psi)
into the clean side of the fi lter (in the opposite
direction of the airfl ow).
Method "C"
Vacuum loose dust from the fi lter. Rinse the
fi lter under a gentle stream of water (maximum
pressure 40 psi). Let the fi lter dry completely
before putting it back into the machine. It is
recommended to have a spare fi lter on hand to
use while the washed fi lter is drying out.
7. Keep Ledge (HD) clean of any dust or debris, this
is where the fi lter gasket contacts the hopper.
8. Follow the instructions in reverse order to install
the fi lter. If the gasket on the fi lter is torn or
missing, it must be replaced. NOTE: Be sure to
reinstall so that the air fl ow decal is pointing up as
shown.
A - 38
INSTRUCTIONS FOR USE
HA
17
16
CS7010 - 56091206
HB
HC
HD
16
FIGURE 21
4/2017