Milwaukee 0501-02 Manual Del Operador página 4

Charge only MILWAUKEE 12 and 14.4 Volt
Power Plus battery packs in Power Plus
chargers. Other types of batteries may ex-
plode causing personal injury and damage.
Charge your battery pack before using your tool for the first time and
when your tool no longer performs with the power and torque needed for
the job. Full loading capacity of battery pack is only reached after
4 - 5 chargings. Never completely discharge the battery pack. Standard
charging time will vary according to the type of charger you use. The
charging time will also vary depending on the supply voltage and charge
needed. For example, if your battery pack does not require a full charge,
charging time will be less.
FOR SPECIFIC CHARGING INSTRUCTIONS, PLEASE READ THE
CHARGER INSTRUCTION SHEET SUPPLIED WITH YOUR CHARGER.
Battery packs are affected by temperature. Your battery pack will
perform best and have longest life if it is charged when the temperature
is between 60°-80°F (15°-27°C). Do not charge in temperatures below
40°F (5°C) or above 105°F (40°C). Under these conditions, capacity will
be reduced. See "Maintenance".
Removing Battery Pack from Tool
Push in the release buttons and remove the battery pack.
Inserting Battery Pack into Tool (Fig. 1 & 2)
Battery pack can be inserted into the tool in two ways.
1. For working in restricted spaces.
Insert the battery pack from the front by pressing in the release but-
tons and sliding battery pack into the body of the tool (Fig. 1). Insert
the battery pack until clamp engages.
page 4
CHARGING AND USING BATTERY PACK
WARNING!
Fig. 1
Cat. No. 0501-02
2. For optimum weight distribution and balance.
Insert the battery pack from the back by pressing in the release but-
tons and sliding the battery pack into the body of the tool (Fig. 2).
Insert the battery pack until clamp engages.
Fig. 2
Cat. No. 0501-02